1953 Shepherd Runabout: How to Apply Final Coat of Varnish

Yes, she is Voodoo Child, and if all goes well this fall and winter, you can see her in Tavares, FL, at the Sunnyland ACBS show, March 24-26, next spring.

John and RJ are making one final pass hand sanding to a snow field using 400 grit paper. The goal is an absolutely dirt-free, super flat surface, in preparation for applying the 20th and final coat of varnish.

We had her name applied following the 16th coat, to which four more coats have been applied. I am well aware that this issue is similar to asking five economists’ forecast for the economy and receiving at least seven conflicting replies. However, my goal is to provide some UV protection to the vinyl, while also delivering an identically glossy presentation across the transom.

We will allow the varnish to cure until early next week, at which time we will install the dual quad four, 331 cubic inch, V-drive Chrysler Marine Hemi and its drive line. The gauge cluster and the steering, throttle and shifting systems will be installed as well. Add a couple of fender cleats and we should be good to go.

Go where? To splash in Lake Champlain, since, before I can make a final commitment to Sunnyland, I must know she’s ready to romp.

After she triumphs over her sea trial, Voodoo Child will sit for 30 days during which time the varnish will finish curing, or at least have cured sufficiently to support the polishing process that completes her preservation.

Finally, we will put her back together and banish her to storage until March, 2017, when we will tow her south, away from a still-frozen Lake Champlain and equally frozen Vermont.

…Just cannot wait ….

Leave a Reply

Your email address will not be published. Required fields are marked *